3D printed bridge in Groningen passes force test with ease

Author without image icon
editors
28 September 2017
3 min

A component of a new 3D-printed road bridge in Groningen has successfully passed an initial force test. Indeed, the material turned out to be twice as strong as previously estimated.

Above expectations

For the important and globally unique test, a 3D-printed girder of about 3.5 metres was used. The developers had estimated that the bridge should be able to support about six tonnes, which is equivalent to three large concrete slabs of 1,300 kg each on this one girder. This would demonstrate that the material could act as a road for both cars and trucks. In the end, it turned out that the structure also managed to hold ten slabs, well above the estimated carrying capacity. Only a few hairline cracks appeared in the concrete.

'This means we can continue developing,' FDN Group engineer Dil Tirimanna told Dagblad van het Noorden. 'Because that is the main thing when building a structure: that it is safe. We did demonstrate with this that you can derive a lot of bearing capacity from printed concrete through design and material combinations.' The printed concrete is made from a mixture of Weber Beamx.

Slimmer

Trimana believes this means that the world's first printed car bridge could have a slimmer shape than originally thought. The first test girder used was made by Eindhoven University of Technology last month, with the province of Groningen initiating the project entirely as part of 'Smart and Green', . The test girder is three times smaller than the original that will soon be used for the final bridge. The printed road bridge consists of a foundation, bridge deck and railings, which will be built with printed parts.

In the final construction of the bridge, eight girders, each ten metres long, will lie side by side. The arch shape directs the forces to the foundation. A layer of UHSB concrete will be laid on top. The bridge has yet to pass a black test. Trucks will be used to test whether the 3D bridge can actually carry sufficient loads. 'If it all turns out well, we will then make a printed bridge 20 metres long. We expect that this arch structure too can take a lot.'

Material quality

FDN Engineering + Construction and TU Eindhoven will now delve even deeper into material quality research. All parties involved in the project prefer to use ultra-high strength concrete (USHB) for the construction of the bridge. Especially for such bridges, this would be the ultimate material, but for various reasons, its application is not yet possible. That is also why a slightly lower quality is used for the bridge in Groningen. It involves concrete with a strength between C30 and C55.

The girders form part of a ten-metre-long car bridge being built in Blauwestad. This is unique; bicycle and footbridges have been 3D-printed before, but not a bridge for cars. The bridge is expected to be ready for use next year.

 

By: Kelly Bakker

Source: DVHN/Vraagenaanbod.nl