Anyone driving along the A18 towards Doetinchem will not fail to notice them: the new high-voltage pylons along the motorway. They have been produced by the VDL Groep. The pylons are part of the TenneT/Amprion 380 kV connection between Doetinchem and German Wesel.
The high-voltage line should facilitate the exchange of electricity between our country and that of its eastern neighbours. For instance, if there is a strong wind in Germany, where there are many wind turbines, a power surplus arises there. The residual power can then be exported to the Netherlands via the new high-voltage line. The pylons are between 55 and 75 metres high.
Each mast consists of several parts. VDL Technics is responsible for the upper and usually longest section (sometimes up to 30 metres long) but also has a share in the lower part of the mast. There, there is a door through which employees can go for maintenance and inspections. Around the door are so-called manholes, large steel rings. VDL made these manholes using SolidCAM software.
Wim Hoezen, engineer at VDL Technics, says: "The pylons are all different and tailored to the location and function. As a result, different manholes also have to be made so that they always follow the shape of the pipe."
Additional CAM module
The manholes arrive cast at VDL Technics. There are two casting templates, from which different rings are milled using SolidCAM. "We made a template of one ring. By reusing this template, we can quickly create the programme for another type of manhole," says Hoezen.
VDL extended its CAM software especially for this project with an extra module. Hoezen: "To be able to mill the conical surface of the manholes, we purchased the HSS module. As this was a new way of programming for us, we attended a one-day training course through our reseller CAD2M, on-site and specifically focused on this product."
Favourable production price
VDL Technics has managed to keep the production price of the manholes as low as possible. This is because the dimensional accuracy is not that high. "Of course the manholes have to fit neatly to the pipe but because they cannot be seen from outside, the smoothness of the surface is less important. Using SolidCAM, I was able to compare the 3D model with how the product would be milled. Together with the customer, we looked at what the surface should look like. We mill with circular inserts and the closer we put the milling paths together, the smoother the surface becomes. However, using more milling paths also increases production time and costs. Because SolidCAM allowed us to show the end result without milling a product, we were able to achieve the optimal balance between price and product appearance."
Construction of the high-voltage line is expected to be completed by mid-2017.
By: Kelly Bakker
Photo: VDL